NHT Evolution System - Manual (Page 18)

Step 3: Attaching the Monitor Connection
Harness
The Monitor Connection Harness connects the
Monitor’s speaker terminals to the terminal cup
on top of the subwoofer module. This terminal
cup is internally wired to the uppermost of the
two terminal cups at the bottom rear of the sub-
woofer module. Remove the two gold-plated
screws from the terminal cup on the top of the
B5 or B6 with the #2 screwdriver. Insert the ring
terminal ends of the cable onto the screws and
fasten them into the terminal cup. Check that
the wire is oriented vertically and that you have
connected the red ring terminal to the bass mod-
ule terminal marked in red (and the black ring
terminal to the bass module terminal marked
with black).
Step 4: Installing the Mounting Buttress
The mounting buttress secures the monitor to
the bass module. Place the buttress over the
four threaded holes on the top of the bass mod-
ule. Start four of the smaller screws (10-24) with
the #2 screwdriver. Center the buttress by mea-
suring the distance between the base of the but-
tress and the speakers’ edge in a few places as
illustrated. Once you have checked alignment
you may tighten the screws, making sure they
are snug, but do not over tighten them.
Step 5: Route Monitor Connection Harness
Route the harness through the channel inside
the buttress as shown below.