4 installation: power/data cable – Navman 5605 User Manual
Page 55
TRACKER 5505/5505i/5605 Installation and Operation Manual
55
NAVMAN
Black
Power/data cable
Red
Yellow
Black
External beepers or
lights
Main switch
12 /24V DC
Fuse 2A
The power/data cable has a black locking collar and flying leads.
1 Wire the TRACKER for auto power to have the TRACKER turn on with the boat’s ignition switch or
to record engine hours or to record the total fuel used. Otherwise wire for basic power (for more
information, see section 2-2).
Basic power
Power/data cable
Yellow
Red
Black
Ignition
Ignition switch
Main switch
12/24 V DC
Fuses 2A
Power/data cable
Red
Green
2 Wire any external alarm beepers or
lights. The alarm output switches to
ground to sound the alarm. If the current
is more than 200 mA, fit a relay.
3 Connect the power/data cable to the
black display unit connector; turn the
collar to lock the connector.
Black
Black
15-4 Installation: Power/Data cable
Auto power
During setup, set up Auto power off (see sections 2-2 turning on and off and 14-1 Setup system)
www.Busse-Yachtshop.de email: [email protected]