beautypg.com

Caution, Caution danger warning, 1-3 following a route – Navman 5605 User Manual

Page 17

background image

TRACKER 5505/5505i/5605 Installation and Operation Manual

17

NAVMAN

Preparing
A route is a list of waypoints that the boat can
follow (see section 6).

To create waypoints before creating the
route, see section 5-2-1.

To create a route, see section 6-2-1.

Starting a route from the chart display:
1 Go to the chart display.
2. Press and select

Start Route.

3. Press or to highlight the route to

follow. Press .

4. The TRACKER asks for the direction to

traverse the route.

Select

Forward

(the order the route was

created) or

Reverse

.

5. The TRACKER displays the chart with the

route marked and starts navigating from

the start of the route.

Starting a route from the routes display:
1 Go to the routes display.
2 Press

or

to highlight the route to

follow. Press

and select

Start.

3 The TRACKER asks for the direction to

traverse the route.

Select

Forward

(the order the route was

created) or

Reverse.

3-1-3 Following a route

4 The TRACKER displays a chart with the

route marked and starts navigating from
the start of the route.

Navigating
The TRACKER navigates to each waypoint on
the route in turn as described in section 3-1-1.
The TRACKER stops navigating to the waypoint
at the end of the current leg and starts the next
leg of the route:
a when the boat comes within 0.025 nm of

the waypoint

b or when the boat passes the waypoint
c or if you skip the waypoint.
Skipping a waypoint
To skip a waypoint, go to a chart display, press

and select

Skip

. The TRACKER starts

navigating straight towards the next waypoint
on the route.

Cancelling a route
When the boat has reached the final waypoint,
or to stop the boat following the route at any
time, cancel the route. Go to a chart display,
press

and select

Cancel route.

Tip: Before starting, create waypoints at points of interest. Create a waypoint at the start of the

trip for you to navigate back to (see section 5-2-1).

Going to a point on the chart
1 Switch to a chart display.
2 Move the cursor to the destination point:

either use the cursor keys or use Find (see
section 3-2-5).

3 Press

and select

Goto cursor.

Navigating
The TRACKER navigates to the point as
described in section 3-1-1.
Cancelling navigating
Go to a Chart display, press

and select

Cancel goto.

CAUTION

!

!

CAUTION

DANGER

WARNING

Make sure the course does not pass over
land or dangerous waters.

CAUTION

!

!

CAUTION

DANGER

WARNING

Skipping a waypoint with the autopilot on
might result in a sudden course change.

www.Busse-Yachtshop.de email: [email protected]