Nvidia Creative Graphics Blaster RIVA TNT2 - Manual (Page 5)

Graphics Blaster RIVA TNT2 Value Installation Guide 5
8. Press the card’s bus connector gently and evenly into the slot, making sure that the bus
connector comes into full contact with the slot. Then, secure the card to the computer casing
with a screw. See Figure 3 below.
9. Connect the monitor cable to the VGA Out connector of Graphics Blaster RIVA TNT2
Value, as shown in Figure 4.
10. Replace the computer cover and plug the power cord back into the wall outlet.
Figure 3: Securing the graphics card to the slot.
ii.Secure the card to the slot
with a screw.
i. Gently and evenly press the card’s
bus connector into the slot.
Warning: Do not force the graphics card
into place. If it does not fit properly, gently
remove it and try again.
If you are using a multi-
frequency monitor, you may need
a special 15-pin PS/2-compatible
adapter cable. If your multi-
frequency monitor allows you to
switch between ‘TTL’ and
‘analog’ operation modes, set the
switch to ‘analog’. For details,
refer to your monitor’s manual.
Figure 4: Connecting your VGA monitor to Graphics Blaster RIVA TNT2 Value.
VGA Out
connector
Graphics Blaster
RIVA TNT2 Value
VGA Monitor
cable
VGA monitor
GB_M64.fm Page 5 Monday, May 31, 1999 11:09 AM