NetComm NP6800 - Manual (Page 26)

www.netcomm.com.au Rev.1 - YML655
Page 26 NP6800 - Wireless LAN Access Point
Operation Mode
The NetComm NP6800 Wireless LAN Access Point can be configured to three different modes
of operation:
■ Access Point,
■ Access Point Client
■ Wireless Bridge (Point to Point or Point to Multipoint).
For each mode you can either view or modify the Wireless LAN parameters of the Wireless
Operational Settings window.
Access Point Mode
The NP6800 Wireless LAN Access Point is set to Access Point by default and will connect
your wireless computer to a wired network (LAN). It is recommended that WEP be configured
to block unwanted access to your network.
In most cases, no change is necessary, however the WEP key identification number and
encryption used must be consistent to enable access.