NetComm NP6800 - Manual (Page 15)

Rev.1 - YML655 www.netcomm.com.au
NP6800 - Wireless LAN Access Point Page 15
2. Click on the Configuration button to display the values stored within the Access Point.
It is important to configure the following settings before continuing:
■ IP Address and Subnet Mask
■ Community (Password)
■ WEP
Note: Refer to the table on Page 40 and write down the changes you make to
your Access Point configuration for future reference.
Other settings may also be changed at this point, however, the following settings are covered
in detail to make the necessary changes to install your Access Point.
IP Address
You may wish to change this IP setting from the default of “192.168.168.10”. A table is
provided on page 40 for you to record the amended setting.
1. Double-click on the Eth_IP_Address to display the following window:
2. Type in the new IP Address and click the OK button.
3. Click on the Set button to configure the Access Point.
Subnet Mask
You may wish to change this IP setting from the default of “255.255.255.0”. A table is provided
on page 40 for you to record the amended setting.
1. Double-click on the Eth_SubMask to display the following window:
2. Type in the new SubNet Mask and click the OK button.
3. Click on the Set button to configure the Access Point.