Nortel Networks LIP-6812 - Manual (Page 12)

LIP-6812 User Guide
9 June 07
NOTE: Your IP phone will not recall the last call dialed number after a loss of system power.
2.10. Last Call Return
You can dial the number associated with the last incoming call, allowing you to return a call to
the caller.
To call back the last incoming caller:
1) Press [LCR ] Softkey.
2.11. Speed Dial Buttons
Programmable buttons on the LIP-6812 can be assigned for Speed Dial; pressing the button will
automatically select your Line and dial the stored number (refer to the Installer Guide for the
steps to configure Speed Dial).
To make a call using Speed Dial:
1) Press the desired Speed Dial button, or lift the handset and press the desired Speed Dial
button.
2.12. Speed Number Dialing
Within the Phone Book menu, you can set a Speed Number (0 to 99) for each Phone Book
record. The Speed Number can then be used to automatically dial the telephone number for the
record. Speed Number dialing must be enabled for use (refer to the Installer Guide for steps to
configure the Speed Number feature).
To make a call using Speed Number:
1) Dial the Speed Number (0-99) for the desired number, or lift the handset and dial the
desired Speed Number.
NOTE: When the Speed Number you dial is empty, the call is terminated and the LCD will
display the error “Empty speed number.”
2.13. DND (Do-Not-Disturb)
The DND (Do Not Disturb) feature places the LIP-6812 in a ‘no-ring’ state. If the LIP-6812 is in
DND, an incoming call to your extension will not cause the phone to ring. To use this feature,