Napoleon Fireplaces BGNV40-P - Manual (Page 20)

20
W415-0813 / A / 04.19.10
6.4 LOG PLACEMENT
Phazer TM logs, glowing and charcoal embers, exclusive to Wolf Steel Ltd. appliances, provide a unique and
realistic glowing effect that is different in every installation. Take the time to carefully position the embers for a
maximum glowing effect.
6.4.2 Place log #1 diagonally across the textured
burner cover onto the studs. The texture is
designed to cradle the underside of the log.
LOCATING
STUDS
LOCATING SCREWS
6.4.3 Depending on the type of installation, the
view of the log positioning will reverse. Here
the lower end of log #2 rests near the back
left corner of the fi rebox on the locating stud.
The upper end sits on top of log #1, inside
the groove on log #2. 6.4.4 Log # 3 is made up of two pieces, a and b.
Piece #3a is the base of log #3. The base
sits diagonally in the designated area located
between logs #1 and fi ts tight up against #2.
6.4.1 Looking at the appliance from the valve side,
place the fi bre burner onto the locating screws
on the pan burner as illustrated above. It is
important not to cover any burner ports with
the fi bre burner.
!
WARNING
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
76.1A