Napoleon Fireplaces BGNV40-P - Manual (Page 19)

19
W415-0813 / A / 04.19.10
6.0 FINISHING
6.1 HEAT SHIELD STAND-OFF REMOVAL (SEE-THRU INSTALLATION ONLY)
HEA
T SHIELD
ST
AND-OFFS
END HEAT
SHIELD SHOWN
When using a non-combustible fi nishing material, the stand-offs may be removed, by
removing the set screw in the centre and sliding the stand-offs out of the mounting
clips.
6.2 DOOR INSTALLATION
DOOR OPENING AND CLOSING: The upper louvres must be removed to allow the door to be opened or
closed. To access the lower door latch, open the valve control door. Release the top and bottom door latches,
located at the right side of the door.
!
WARNING
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
75.1
6.3 END DOOR INSTALLATION
Ensure that the door is properly clipped onto the steel lip to prevent overheating, glass breakage and / or dis-
coloration of the upper trim.
To install the door(s), hook it over the steel lip located above the door opening.
Secure with screws along the bottom of the door. Tighten screws snugly. Do not over-tighten.
DOOR
STEEL LIP