NEC MultiSync XG-1352 - Manual (Page 8)

8
4 SOUND MUTE Button
Press to mute the sound. Press again to return the sound.
NOTE: This works only with the ISS-6020/ISS-6020G
Switcher.
5 DISPLAY Button
Press to turn on or off the on-screen display. Pressing with
CTL eliminates the on-screen display; pressing with CTL
again restores it.
NOTE: Even if the on-screen display may be turned off
with pressing CTL and DISPLAY, any adjustment will
still change the projector’s memory settings. This mode
is available even when an input is switched to another or
the power is turned off using the POWER OFF button on
the remote control.
6 STATIC Button
Press to enter the STATIC mode. You can adjust the static
convergence.
7 R and B Buttons
Turn each CRT beam on and off separately. When using
with the CTL button, you can select the CRT to be
adjusted during static convergence.
8 CTL Button
Used in conjunction with other buttons, similar to a shift
key on a computer.
9 NORMAL Button
Returns the standard level for each signal. When pressed
once, the confirmation message will be displayed. When
“YES” is selected and ENTER is pressed, the data will be
returned to the standard level. While holding down the
CTL button, press the NORMAL button to display the
“LOAD/CANCEL” menu to select either LOAD (last
stored level) or CANCEL (data cancelled).
0 INPUT Buttons
Select menus and switches input signals.
A CAPTION Button
Press to display the CLOSED CAPTION menu.
B CURSOR Buttons
Used for increasing and decreasing control levels, cursor
movement and convergence adjustments.
C END Button
Ends the adjustment mode.
D ENTER Button
Executes menu selection and switches to selected input.
PART NAMES AND FUNCTIONS
Remote control unit
User Remote Control
RC-6320
NOTE: The full function remote control is designed for setup
adjustment. Use the user remote control for normal
operation.
1 POWER Buttons (ON/OFF)
Press the ON button to turn the projector on when the
projector is in the standby condition (STANDBY and RC
READY indicators lit). Press the OFF button to return the
projector to the standby condition.
2 OPERATE Button
Press to display the “OPERATE” menu.
3 PICTURE MUTE Button
Press to mute the picture. Press again to display the
picture. You can also mute the picture by holding down
CTL and pressing PICTURE MUTE buttons. To restore
the picture, holding down CTL and press PICTURE
MUTE again. Or simply press END.
NOTE: When the picture is muted by using CTL and
PICTURE MUTE buttons, even if an input is switched to
another or the power is turned off using the remote
POWER OFF button, the mute cannot be canceled.
POWER
ON OFF
OPERATE
PICTURE
MUTE
SOUND
MUTE
1 ABC 2 DEF 3 GHI
4 JKL 5 MNO 6 PQR
7 STU 8 VWX 9 YZ /
10 ,.
R
B
END CTL
DISPLAY
STATIC
NORMAL ENTER
1
0
B
C
D 9
8
7
6
5
4
3
2
CAPTION
A