National Instruments Fieldbus - Manual (Page 14)

Chapter 2 Hardware Installation and Configuration
© National Instruments Corporation 2-3 FBUS-HSE/H1 LD User Manual
Mounting the FBUS-HSE/H1 LD to a Panel
Complete the following steps to install the optional Fieldbus network panel
mount accessory and mount the FBUS-HSE/H1 LD network module to a
panel. You can order the panel mount accessory from National
Instruments.
1. Use a flathead screwdriver to open the rail clip to the unlocked
position, as shown in Figure 2-1.
2. Snap the panel mount accessory onto the module, as shown in
Figure 2-3.
Figure 2-3. Installing the Network Panel Mount Accessory
3. Lock the panel mount accessory into place by pushing the rail clip to
the locked position.
4. Mount the FBUS-HSE/H1 LD to your panel with the panel mount
accessory.