Instructions for use – Philips SRU 5030/86 User Manual
Page 7
! / . . . . . . . . . . . . . . . . selects between one- and two-figure channel
numbers.
@ 2
2 . . . . . . . . . . . . . . . . selects previous programme/channel.
# - PROG + . . . . . . . . . selects a previous or following channel.
$ OK . . . . . . . . . . . . . . . confirms your selection.
% BACK. . . . . . . . . . . . . jumps back one level in the menu or turns off the
menu.
^ TV/DVD/VCR . . . . . selects TV, DVD or VCR mode.
If you use the (fi) 'memory off' key to get to the next teletext page on your
Philips TV, you can press the Subtitle key for this. See also ‘Troubleshooting’.
•
If the device does not respond at all, or not to all of the key
commands, follow the instructions under ‘Setting the remote
control’. It is possible that you must enter another code for the
device.
4. Extra possibilities
Adjusting device selection (Mode keys)
The SRU 5030 is default set for operating TV, DVD or VCR.You can select
the device you wish to operate with the TV, DVD and VCR keys. Each key
allows operation of one device only. If desired, you can program the keys to
select a different kind of device. For example, if you want to operate a
second TV.
In the following example you will see how to configure the DVD key for a
second TV.
1
Switch on the second TV.
2
Press the DVD key to select DVD.
Press the key until it lights up.
3
Then keep keys 1 and 6 on the SRU 5030
pressed simultaneously for three seconds,
until the DVD key lights up.
4
Press keys 9, 9 and 2 in that order.
8
Instructions for use
English