beautypg.com

Instructions for use – Philips SRU 5030/86 User Manual

Page 5

background image

4

Press and hold the Standby key
of the SRU 5030.

The SRU 5030 now starts emitting all known
‘TV off ’ signals, one by one.
Each time a code is sent, the TV key lights up.

5

When your TV switches off (stand-by), release the Standby key of the
SRU 5030 immediately.

The SRU 5030 has now found a code that works on your TV.

6

Check if you can operate all functions on your TV with the SRU 5030.

If this is not the case, you can redo the automatic setting.
The SRU 5030 will then search for a code that works better.

After the SRU 5030 has run through all the known codes, the search
will stop automatically and the TV key stops flashing.

Automatic programming of a TV takes a maximum of 5 minutes.
For DVD and VCR this time is 2 minutes.

Manually setting the remote control
Example of TV:

1

Turn on the TV manually or use the original remote control.
Tune in to channel 1.

2

Look up the brand of your TV in the
code list at the back of this manual.
One or more four-figure codes are shown for
each brand.
Note the first code.
Be careful! There are separate tables for TV, DVD
and VCR.

On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.

Make sure you use the codes from the correct table.

3

Press the TV key to select TV.
Press the key until it lights up.

4

Keep keys 1 and 3 pressed simultaneously
for three seconds until the TV key flashes
twice and then remains lit.

6

Instructions for use

English

This manual is related to the following products: