Nortel Networks 302403-B - Manual (Page 19)

17
Installing an MDA
The Uplink Module slot on the BayStack 450 switches
accommodates a single MDA. The connection can be
either an RJ-45 10/100BASE-TX MDA or a fiber
(100BASE-FX or 1000BASE-SX/LX) MDA with an SC
or MT-RJ connector.
To install an MDA into the Uplink Module slot, follow
these steps:
1. Unplug the AC power cord from the back of the
switch.
2. Loosen the thumb screws and remove the filler
panel (or previously installed MDA) from the
Uplink Module slot.
Note: The MDA is not hot-swappable. Power down
the switch before installing or removing an MDA.
Note: If you are replacing an installed MDA with
another type of MDA, see “Replacing an MDA with a
Different Model ” on page 19 .
302403-B.mkr Page 17 Friday, January 15, 1999 2:56 PM