Nortel Networks ICS 4.1 - Manual (Page 70)

Page 64
Compact ICS 4.1 Programming Record P0906186 Issue 02
••• Remote pkg Select whether a Class of Service password will use the default remote package or a different
remote package (enter the two-digit remote package number).
• Call log pswds A programming section that allows you to clear any Call Log password programmed with the
Call Log feature.
•• Show set:_ Enter the DN of the telephone you want to program.
••• Log pswd Erase the call log password for this telephone.
• Programing pswds In this section you can create your own programming password rather than use the default.
•• Installer Enter the new installer password which gives you access all the programming settings.
•• SysCoord+ Enter the new system coordinator password which gives you access to selected programming
settings.
•• Sys coord Enter the new system coordinator password which gives you access to everyday programming
settings.
•• Basic Enter the new basic password which gives you access to the most commonly used programming
settings.
• IRAD pswd View or change the password used for remote programming.
• Hospitality A programming section that allows to create Hospitality services passwords if required, rather
than use the defaults.
•• Desk pswd Enter the new Desk password which gives access to all Hospitality services programming
settings.
•• Cond pswd Enter a Condition password which gives certain employees access to the Room condition
programming settings in Hospitality services.
Time&Date A programming section that lets you set the system's clock to the correct time and date.
System prgrming A programming section that lets you change system-wide settings, Auto Attendant, and CCR
programming
• Hunt groups A programming section that lets you set up incoming calls on a specific DN to be routed to a
group of sets.
•• Show group:_ Enter the DN of the telephone you want to program.
••• Member DNs Enter the DN of the telephone you want to add to the group.
•• Line assignment Allows you to assign or unassign a line to a particular hunt group.
•• Mode: Allows you to determine how an incoming call will be handled by the hunt group.
•• Hunt delay: Select a delay value to determine how long a set rings before the call moves on the next member
set.
•• If busy: Allows you to determine how an incoming call is to be treated when all hunt group member sets
are busy.
•• Q Timeout: Allows you to set the number of seconds the incoming call remains in the hunt group call queue
before it is offered to the overflow position.
•• Overflow: Enter the DN of the set you want the hunt group overflow calls to be presented.
• Change DNs Change the DN of a telephone. All DNs must be the same length. The first digit of a new DN
cannot be the same as the external line access code, the Call Park prefix, the Direct-dial digit,
or the first digit of a line pool access code. If you change an individual DN, you must quit
programming for the change to take effect. If you have additional programming to do, quit and
then begin a new programming session.
• Featr settings Programming for features that are used system-wide.