Nikon Coolpix S610 - Manual (Page 138)

126
Troubleshooting
T
e
chni
cal N
o
te
s
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
and then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon representative. Note that disconnecting the power source as
described above may result in the loss of any data not recorded to internal
memory or the memory card at the time the problem occurred. Data already
recorded will not be affected.
Shooting
Date imprint not available Camera clock has not been set. 18,
104
Date not appearing on pictures
even when Date imprint is
enabled The date is not imprinted on movies or on
pictures taken in Panorama assist scene mode. 61, 108
Camera settings reset Backup battery is exhausted; all settings were
restored to their default values. 105
Monitor turns off, and the
power-on lamp blinks rapidly. Battery temperature is high. Turn off camera,
and allow battery to cool down before resuming
use. After the lamp blinks for three minutes, the
camera will turn off automatically, but you can
also press the power switch to turn it off
manually. 15
Problem Cause/Solution A
No picture taken when shutter-
release button is pressed • When camera is in playback mode, press the
c button.
• When menus are displayed, press the d
button.
• Battery is exhausted.
• When flash lamp blinks, flash is charging.
28
11
22
31
Camera cannot focus • The intended subject is one with which
autofocus does not perform well.
• Set AF assist in the setup menu to Auto.
• Focus error. Turn camera off and then on
again.
27
110
15
Problem Cause/Solution
A