Napoleon Fireplaces GD70NT-S - Manual (Page 19)

19
W415-0434 / C / 03.24.05
The FIRE LOG ACCENT LIGHT is provided with a manual "in-
line" switch to turn the light on and off. There are alternate meth-
ods of operating the light.
An example of one method would be to "hard-wire" a wall switch.
The switch could be installed in desired location to operate the
FIRE LOG ACCENT LIGHT plugged into one of the two recepta-
cles on the fireplace junction box. The other receptacle would still
have power to operate other accessories (see schematic be-
low).
This switch could be:
• Toggle
• Photo cell
• Remote
• Motion Sensor
All switches are available at your building store.
NOTE
ELECTRICAL INST
ELECTRICAL INST ELECTRICAL INST ELECTRICAL INST ELECTRICAL INSTALL ALL ALL ALL ALLA A A A ATION T TION T TION T TION T TION TO BE DONE BY A O BE DONE BY A O BE DONE BY A O BE DONE BY A O BE DONE BY A
QU QU QU QU QUALIFIED INST ALIFIED INST ALIFIED INST ALIFIED INST ALIFIED INSTALLER ALLER ALLER ALLER ALLER and m and m and m and m and must be connected and ust be connected and ust be connected and ust be connected and ust be connected and
g g g g grrrrrounded in accor ounded in accor ounded in accor ounded in accor ounded in accordance with local codes dance with local codes dance with local codes dance with local codes dance with local codes.....
Your Napoleon STARfire comes equipped with our “Accent
Lite”. The light has been pre-wired and can be controlled
from the switch on the control panel.
It is recommended that the ACCENT LITE be in the off
position when the fireplace is on.
If in the event the lamp
or lens needs to be
replaced, follow the
instructions below.
Unplug the light from
inside the fireplace.
Remove the four screws that secure the lens frame.
This frame
retains the
glass lens.
The lamp can
now be
accessed.
Note: Note: Note: Note: Note: Do not handle the lamp (bulb) with bare fingers, Do not handle the lamp (bulb) with bare fingers, Do not handle the lamp (bulb) with bare fingers, Do not handle the lamp (bulb) with bare fingers, Do not handle the lamp (bulb) with bare fingers,
protect with a clean dry cloth. protect with a clean dry cloth. protect with a clean dry cloth. protect with a clean dry cloth. protect with a clean dry cloth.
The lamp will pull straight out of the socket. Replace with
Wolf Steel parts only, as lamp and lens are special “high
temperature” products.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Ov Ov Ov Ov Over tightening the scr er tightening the scr er tightening the scr er tightening the scr er tightening the scre e e e ews could br ws could br ws could br ws could br ws could break the lens eak the lens eak the lens eak the lens eak the lens.....
“Light Leakage” from the upper louvre area may be “Light Leakage” from the upper louvre area may be “Light Leakage” from the upper louvre area may be “Light Leakage” from the upper louvre area may be “Light Leakage” from the upper louvre area may be
noticed. The holes in the lamp housing are necessary noticed. The holes in the lamp housing are necessary noticed. The holes in the lamp housing are necessary noticed. The holes in the lamp housing are necessary noticed. The holes in the lamp housing are necessary
for ventilation and must not be covered. for ventilation and must not be covered. for ventilation and must not be covered. for ventilation and must not be covered. for ventilation and must not be covered.
ACCENT LITE REPLACEMENT
FIGURE 47
FIGURE 49
IN LINE SWITCH
FIGURE 50a
FIGURE 50b
LENSE
ASSEMBLY
FIREBOX TOP
LENSE
ASSEMBLY
FIREBOX TOP
SCREWS SCREWS
FIGURE 48