NEC MT1035 - Manual (Page 25)

25
Connecting Your PC Or Macintosh
Computer
Connecting your PC or Macintosh computer to your MultiSync
MT1035 (XGA) Projector will enable you to project your computer's
screen image for an impressive presentation. All of these following
display standards are supported:
To connect to a PC, Macintosh or computer equipped with an XGA/
SVGA /VGA adapter or compatible graphics adapter, simply:
1. Turn off the power to your projector and computer.
2. If your PC does not support XGA/SVGA/VGA you will need to
install an XGA/SVGA/VGA graphics board. Consult your
computer's owner's manual for your XGA/SVGA/VGA configura-
tion. If you need to install a new board, see the manual that comes
with your new graphics board for installation instructions.
VGA 640
ן480 for graphics
VGA 640
ן400 for graphics
VGA 640
ן350 for graphics
VGA 720
ן400 for text
VGA 720
ן350 for text
SuperVGA 800
ן600
Macintosh at 640
ן480
Macintosh at 832
ן624
XGA1024 ן768 Macintosh at 1024 ן768
SXGA1280
ן1024 (Accu-Blend)
Settings for Monitor Mode
Number of DIP switch
Monitor size
15” multi-scan mode /16”–13”
17” multi-scan mode /19”–13”
19” multi-scan mode /21”–13”
13” fixed mode /640 ן480
VGA/SVGA mode
16” fixed mode /832 ן624
19” fixed mode /1024 ן768
S1
ON
ON
ON
ON
S2 S3 S4
ON
S5
ON
ON
S6
ON
S7
ON
S8
ON
NOTE: For settings other than display modes supported by your
Macintosh and MT1035, use of the DIP switch may bounce a image
slightly or may display nothing. If this happens, set the DIP switch to the
13” fixed mode and then restart your Macintosh. After that, restore to a
displayable mode and then restart the Macintosh again.
Make sure that the MT1035 and your Macintosh are connected with the pin
adapter and the supplied signal cable (mini D-Sub 15-pin connector) and
then restart your Macintosh.
3. Use the signal cable that's supplied to connect your PC or
Macintosh computer to the projector. For a Macintosh, use the
supplied pin adapter to connect to your Mac's video port.
4. Turn on the projector and the computer.
5. If the projector goes blank after a period of inactivity, it may be
caused by a screen saver installed on the computer you've
connected to the projector.
When using a Macintosh with the MT1035, set the DIP switches of
the supplied pin adapter according to your resolution. After setting,
restart your Macintosh.
See the following pages for setting of the DIP switches.
• When using with a Macintosh, XGA/VGA/SVGA (1024
ן768) is
recommended if your Macintosh supports this mode.
• When using with a Macintosh PowerBook, output may not be
set to 1024
ן768 unless “mirroring” is off on your PowerBook.
Refer to owner’s manual supplied with your Macintosh com-
puter for mirroring.
NOTE: A Video Adapter cable manufactured by Apple Computer
is needed for a PowerBook which does not have a mini D-Sub 15-
pin connector.
INSTALLATION
47
48