NAD C715 DAB - Manual (Page 8)

9 TIME MODE: In conjunction with [TUNE/TIME] keys, toggle this button
to cycle through the following timer modes:
Current time on time
Source select off time
Refer to the sections “SETTING ThE CloCk” and “SETTING ThE oN/oFF
TIMER” for a description of the above modes.
10 TONE/BAL/DIMMER: Toggle this button to adjust tone, balance and
dimmer settings in combination with [VolUME] knob.
11 TUNE MODE/SELECT/ [OPEN / CLOSE ]: In FM/AM mode, toggle
this button to cycle through the following tuning modes:
Manual tune Auto tune
Preset tune
In CD mode, press this button to open and close the disc tray.
Use this button in combination with other relevant keys to setup timer
settings.
When in standby mode, this button will also power oN the C 715 and at
the same time open the disc tray.
12 USB: Connect an external USb device into this input.
13 PHONES: Accepts stereo headphone using a standard 1/8-inch stereo
phone plug. Plugging in headphones automatically mutes output from
the speakers; however, subwoofer output will not be cutoff.
14 MP: Connect your MP3’s standard stereo phone jack to this input.
15 TUNE / TIME / [ / ] / [ / ] : In AM/FM mode, press to
step up or down stored presets. Press these buttons for manual or auto
scanning of AM/FM band.
In CD or USb mode, press to skip forward or to skip backward
a track or file. Press and hold or for more than 2 seconds to
search up or down a track or file. Release the button to resume normal
playback.
Use these buttons in combination with other relevant keys to setup
timer settings.
These buttons are also used to step or scroll through applicable options
either independently or in combination with other buttons.
16 REMOTE SENSOR: Point the SR 7 remote control at the remote sensor
and press the buttons. Do not expose the remote sensor of the C 715 to
a strong light source such as direct sunlight or illumination. If you do so,
you may not be able to operate the C 715 with the remote control.
Distance: About 23ft (7m) from the front of the remote sensor.
Angle: About 30o in each direction of the front of the remote sensor.
17 Vacuum Fluorescent Display (VFD): Provides visual information
about the unit’s important modes, settings, functions, status of the
current source like disc playback time and other indicators.
18 VOLUME: Turn clockwise to increase the volume setting; counter
clockwise to lower it. The VFD shows the VolUME setting displayed as
increments between 1 through to 62. “VolUME MIN” will be displayed
when volume setting is at its lowest level and “VolUME MAX” when
volume is at its highest level.
In conjunction with the [ToNE/bAl/DIMMER] button, turn [VolUME]
clockwise or counterclockwise to adjust the tone, balance and dimmer
functions.
IDENTIFICATION OF CONTROLS
FRONT PANEL
EN
G
LIS
H
FR
A
N
Ç
A
IS
ES
PA
Ñ
O
L
IT
A
LIA
N
O
D
EU
TS
CH
N
ED
ER
LA
N
D
S
SV
EN
SK
A
РУ
СС
К
И
Й