Navman Sport Tool M300 - Manual (Page 21)

M300
1-21
NAVMAN M300 - Normal operation
5.1.7 Timer mode
Timer mode lets you monitor session time, lap number and
current lap time. Up to 50 laps may be stored during each
session. Each lap entry resets the current lap time to zero.
Access this mode
If necessary, press to turn the power on and start normal
operation. Press repeatedly until the screen appears as
shown above.
While in Timer mode
• Press to store current lap data (the screen briefly shows the
lap distance, lap number, and lap time that is being stored).
• Press and hold to clear all* session data. (*Does not clear
odometer.)
• Press to go to the next mode.
Note: The timer starts automatically whenever you start moving and
stops whenever you stop moving.
5.1.8 Timer recall mode
This mode lets you recall stored lap data.
Access this mode
If necessary, press to turn the power on and start normal
operation. Press repeatedly until the screen appears as
shown above.
While in Timer recall mode
• press repeatedly to step through lap data
• press to start recall again from lap 1
• press to go to the next mode
lap number
lap time session time
LAP
nmi
LAP
RCL
lap number
lap time lap distance