Navman Sport Tool M300 - Manual (Page 13)

M300
1-13
NAVMAN M300 - Setup
4.1.3 Beep
Set beep ON or beep OFF. When beep is ON, an audible ‘beep’
will sound when buttons are pressed.
Access this option
If necessary, press and hold to turn the power on and enter
setup. Press repeatedly until the screen appears as shown
above.
To set button beep status
1) Press to start editing (setting status flashes).
2) Press or to select On or OFF.
3) Press to stop editing.
4) Press to go to the next option, or hold to leave setup.
4.1.4 Set speed units
Set units for speed (knots, km/h or mph).
Access this option
If necessary, press and hold to turn the power on and enter
setup. Press repeatedly until the screen appears as shown
above.
To set speed units
1) Press to start editing (speed units flash).
2) Press or to select knots, km/h or mph.
3) Press to stop editing.
4) Press to go to the next option, or hold to leave setup.
Note: Distance is displayed in units that correspond to user selected
speed units. For example, if you select speed units ‘km/h’, then
distance is displayed in ‘km’.
speed units
status
SYSTEM
SET
SYSTEM
SET
knots nmi