National Instruments 2 SD Card Memory Module NI 9802 - Manual (Page 9)

© National Instruments Corp. 9 NI 9802 Operating Instructions and Specifications
about support for sleep mode. You can enable sleep mode in
software. Refer to the driver software documentation for more
information.
Caution Do not enable sleep mode while either of the SD
Card slot yellow LEDs are lit or flashing. Enabling sleep
mode while either of the SD Card slot yellow LEDs is lit
or flashing might result in incomplete data.
Typically, when a system is in sleep mode, you cannot
communicate with the modules. In sleep mode, the system
consumes minimal power and may dissipate less heat than it does
in normal mode. Refer to the Specifications section for more
information about power consumption.
Specifications
The following specifications are typical for the range –40 to 70 °C
unless otherwise noted. Certification standards for some
specifications vary based on the system in which you use the
module.