Napoleon Fireplaces GD82NT-T - Manual (Page 19)

19
W415-0666 / 01.28.08
OPTIONAL
FRONT
GLASS
DOOR
RETAINER
LATCHES
Before the glass door can be removed, the optional front must be
removed.
The glass door is secured to the top front edge of the fi rebox. Pull the
handles of the latches forward, then lift the hooks out from the slots
in the door frame to release the top of the door. Next, pivot forward
until the top edge of the door clears the front of the fi replace. Next
gripping the sides of the door lift the door out from the retainer along
the bottom of the door.
FINISHING
FIGURE 36
DOOR REMOVAL
FIGURE 39
BOWL, MESH & ROCK PLACEMENT
FINISHING SECTION
SCREW W/ SPACER
1. Carefully slide the opening in the rear of the bowl over the
burner making sure to line the holes in the bottom of the bowl with
the 2 locating pins on the burner bottom
. (Fig. 38)
2. Place the steel mesh inside the bowl making sure there is even
space between the mesh and edge of bowl. (Fig. 39)
FIGURE 38
3. Carefully place the rocks on the bowl by lining up the locating
notch on the underside of the rock cluster with the opening in the
rear of the bowl. (Fig. 40)
SHIPPING BRACKET
Before installing the bowl
and rocks, you must fi rst
remove the shipping bracket.
Lift up to remove.
UNDERSIDE OF ROCK CLUSTER
FIGURE 40
TOP SIDE OF ROCK CLUSTER
4. After rocks have been placed on the bowl, add the remaining
rock by inserting the pin into the hole shown in (Fig. 41).
FIGURE 41
FIGURE 37