National Instruments VXI/VME 600 - Manual (Page 29)

Appendix A Default Settings
VXI/VMEpc 600 Series for Windows 95/NT A-2 © National Instruments Corporation
W7—CLK10 SMB Polarity
(VXI only) Not inverted
W8—Ethernet EEPROM Enabled. Do not alter this setting.
W9—MITE User Configuration
EEPROM Load values from user side
W11—System Controller Slot
Detection Mode Automatically detect slot
W20—Clear CMOS Disabled. Change only when
clearing CMOS.
Table A-2. VXIpc T&M Explorer Device Tab Default Settings
Editor Field Default Setting
Logical address 0
Device class Message based
Size of Servant area 0
Number of handlers 1
Number of interrupters 0
Table A-3. VXIpc T&M Explorer Shared Memory Tab Default Settings
Editor Field Default Setting
Memory sharing Don’t share memory
Shared RAM size 64 KB (when sharing memory)
Reserved physical memory 64 KB (when sharing memory)
Lower half window byte
swapping Disabled
Table A-1. VXI/VMEpc 600 Series Hardware Default Settings (Continued)
Jumper Description Default Setting Description