National Instruments VXI/VME 600 - Manual (Page 28)

© National Instruments Corporation A-1 VXI/VMEpc 600 Series for Windows 95/NT
A
Default Settings
This appendix summarizes the default settings for the hardware and
software in your kit. If you need more information about a particular
setting, or if you want to try a different configuration, please refer to the
VXI/VMEpc 600 Series User Manual for your hardware reference and the
T&M Explorer online help for your software reference.
Because you can also use T&M Explorer to configure a VXI-MXI-2 or a
VME-MXI-2, this appendix also summarizes the software default settings
for the VXI/VME-MXI-2.
VXI/VMEpc 600 Series
This section summarizes the hardware and software default settings for the
VXI/VMEpc 600 Series. Notice that some of the jumpers described in
Table A-1 are for VXI configuration only.
Table A-1. VXI/VMEpc 600 Series Hardware Default Settings
Jumper Description Default Setting Description
W1—Power On MITE Self
Configuration Enabled. Do not alter this setting.
W2—External Trigger Input
Termination (VXI only) Do not terminate
W3—SCSI Bus Termination Enabled
W4—CLK10 SMB Direction
(VXI only) Receive CLK10
W5—CLK10 SMB Termination
(VXI only) Do not terminate
W6—CLK10 Source
(VXI only) Source from onboard oscillator