NCR S16 - Manual (Page 73)

SCO Release 3: Installing TCP/IP Communications
NCR S16 Minitower Server Installing Network Operating System 8-7
SCO Release 3: Installing TCP/IP
Communications
Always defer Network Installation, because there may not be a driver listed
within the SCO UNIX Installation for the NIC configured in the unit.
Use the latest SCO UNIX drivers for your SCSI controller and NIC.
To install TCP/IP, follow these steps:
1. Enter Maintenance Mode (Press Enter on boot; init 1 or shutdown -i).
2. Begin an Install (/etc/custom, install or sysadmsh, System, Software,
Install).
3. Select A NEW PRODUCT.
4. Select PACKAGES.
Inserting the Latest SMC Driver Disk
To insert the latest SMC driver disk, follow these steps:
1. Insert the latest SMC driver disk and press CONTINUE.
2. The “Select packages from which to choose files and press “
message displays. Select the following:
SMC 8432, 8434 and 9332 Ethernet driver v1.0.2a
3. When the “Insert the requested volume and press to continue the
installation” message displays, press Enter. Verify that the SMC driver is
installed correctly, then exit.
4. At the # prompt, type “netconfig.”
5. Select “1. Add a chain.” “Sco_tcp->lo0” is a “loopback” test and cannot
be used for active IP connections. For the SMC, an entry similar to the
following is listed if installed:
“sco_tcp->smpw0
smpw0 smpw SMC8432, 8434 and 9332 Ethernet Adapter, board
0”