NCR S16 - Manual (Page 105)

Configuration Settings Required for Installing MP-RAS
NCR S16 Minitower Server Installing Network Operating System 11-15
Configuration Settings Required for
Installing MP-RAS
The configuration settings required for MP-RAS are listed in this section.
Hard Disk Group
•
On-Board IDE Hard Disk Controller – Disabled
Parallel Port
•
Enabled - base address 3BCh
Serial Port Group
•
Port 1 – Enabled – address 03F8h
•
Port 2 – Enabled – address 02F8h
Shadow Options
•
E0000h - FFFFFh (System BIOS) – Enabled
•
C0000h - C7FFFh (Video BIOS) – Enabled
•
Memory at 15 MB-16 MB – Reserved for System Use
Cache
•
L1 and L2 Cache – Enabled
•
ECC/Parity Mode Selection – ECC
•
Operation of ECC Correction Enabled
Other Configuration Settings
•
Keyboard control – Enabled
•
On Board PS/2 Mouse (IRQ 12) – Enabled
•
Num Lock after boot – Enabled