Netac Tech T610 - Manual (Page 9)

Netac AirTrack T610 Wireless Broadband Router
4
a. When you build T610 on the wall, avoid to fall down be destroyed, please fix it well.
b. Leave enough roomage around T610, so that can dispel heat normally.
2. Connect T610's 1
#
LAN port with the Network Interface Card port of computer A through an Ethernet
cable.
Note:
a. The length of Ethernet cable connected to computer or LAN cannot exceed 100 meters.
b. User also can connect the Network Interface Card port of computer A with 2
#
3
#
4
#
LAN port of T610.
c. Computer B can communicate with T610 directly by wireless mode.
3. Connect ADSL Modem/Cable Modem/Broad Band/LAN/WAN/Internet with the WAN port of T610
through Ethernet cable.
Note:
This step is not required, but if you want exchange data with exterior, you must use it.
4. Connect the power adapter to T610 correctly.
Note:
Please don’ t use other kind of power adapter, it maybe destroy the equipment.
2.2 Configure TCP/IP
When install Windows 98/Me/XP/2000, it will install TCP/IP protocol default, and configure it as obtain an IP
address automatically. There will be a little difference between different operating system, for Windows 2000,
look into the property of TCP/IP component of computer, please refer to the following steps:
1. Click "Start" menu, select "Settings" and click "Control Panel", double click the “Network and Dial-up
Connections” icon in the pop-up window, this brings up the “Network and Dial-up Connections” dialog
box.