Active data connections, Synchronisation – Nokia 5233 User Manual

Page 97

● Homepage — Depending on the access point you are setting up, enter the web

address or the address of the multimedia message centre.

● Use access point — Select After confirmation if you want the device to ask for

confirmation before the connection using this access point is created, or

Automatically if you want the device to connect to the destination using this

access point automatically.

Select Options > Advanced settings and from the following:
● Network type — Select the internet protocol type to transfer data to and from

your device. The other settings depend on the selected network type.

● Phone IP address (for IPv4 only) — Enter the IP address of your device.

● DNS addresses — Enter the IP addresses of the primary and secondary DNS

servers, if required by your service provider. To obtain these addresses, contact

your internet service provider.

● Proxy server address — Enter the address of the proxy server.

● Proxy port number — Enter the port number of the proxy server.

Active data connections

Select Menu > Settings and Connectivity > Connection mgr..
In the active data connections view, you can see open data connections:

data calls

packet data connections

To end a connection, select Options > Disconnect.
To end all open connections, select Options > Disconnect all.
To view the details of a connection, select Options > Details.

Synchronisation

Select Menu > Settings and Connectivity > Data transfer > Sync.

Connectivity