NEC FP1375X - Manual (Page 6)

English-5
English
Quick Start
To attach the MultiSync FP1375X monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more
information, refer to the display card manual.
3. For the PC Analog output: Connect the VGA to DVI-A signal cable
to the connector of the display card in your system (Figure A.1).
Tighten all screws.
For the PC with DVI digital output: Connect the DVI-D to DVI-D
signal cable to the connector of the display card in your system
(Figure A.2). Tighten all screws.
For the Mac: Connect the Macintosh cable adapter (not included)to
the monitor connector on the Macintosh (Figure B.1). Attach the VGA
end of the captive signal cable to the Macintosh cable adapter on the
computer (Figure B.1). Tighten all screws.
NOTE: Incorrect cable connections may result in irregular
operation, damage display quality/components of CRT
monitor.
Figure A.1
Figure A.2
USB Cable
Detachable
Signal Cable
(VGA to DVI-A)
DVI-A
VGA
USB Cable
Detachable
Signal Cable
(DVI-D to DVI-D)
DVI-D
DVI-D