NEC FP1375X - Manual (Page 19)

English-18
Monitor Troubleshooting
No picture
•
Display card should be completely seated in its slot.
• Power Button and computer power switch should be in the ON
position.
• Signal cable should be completely connected to display card/
computer.
• Check connector for bent or pushed-in pins.
Image is scrolling or unstable
• Signal cable should be completely attached to the computer.
• Check pin assignments and signal timings of the monitor and your
display card with respect to recommended timings and pin
assignments.
• If the Macintosh cable adapter is used, check for proper connection or
make sure the display card is Macintosh compatible and that the card
is properly seated in the computer.
LED on monitor is not lit (no green or orange colour can be seen)
•
Power Switch should be in the ON position and power cord should be
connected.
Picture is fuzzy or colour looks blotchy
•
If the picture is fuzzy, adjust the Moiré Canceler control. If the colour
looks blotchy, adjust the Brightness,Contrast or GlobalSync controls,
or use the EdgeLock control to change modes.
• Access the Degauss Control through OSM controls. Activate the
Degauss Control.
CAUTION: A minimum interval of 20 minutes should elapse before
the Degauss Control is used a second time when not
switching between modes.
Picture bounces or a wavy pattern is present in the picture
•
Move electrical devices that may be causing electrical interference
away from the monitor.
Edges of the display image are not square
•
Use the OSM Geometry Controls to straighten the edges.
• If possible, position the front of the monitor facing east.