NEC FP1375X - Manual (Page 12)

English-11
English
NOTE: For standard systems and graphics boards, keep the factory
setting at ENABLE.
EdgeLock Control: Operating your monitor at a non-standard timing
may cause images to appear darker than normal or have colour
distortion. Use of the EdgeLock control will adjust images to their normal
state.
Video Detect: Selects the method of video detection when more than
one computer is connected.
NONE: The monitor will not search the other video input
port unless the monitor is turned on.
FIRST DETECT: The video input has to be switched to
“FIRST DETECT” mode. When current video input
signal is not present, then the monitor searches for a
video signal from the other video signal input port. If the
video signal is present in the other port, then the monitor
switches the video source input port to the new found
video source automatically. The monitor will not look for
other video signals while the current video source is
present.
LAST DETECT: The video input has to be switched to
the “LAST DETECT” mode. When the monitor is
displaying a signal from the D-Sub and a new secondary
source is supplied to DVI-Analog or Digital, then the
monitor will automatocally switch to the new video
source. When current video input signal is not present,
then the monitor searches for a video signal from the
other video input port.
DVI Selection: This function selects the DVI input mode. When the
DVI selection has been changed, you must restart your computer.
DIGITAL: DVI digital input is available.
ANALOG: DVI analog input is available.
Information
Display Mode: Indicates the current mode and frequency setting of the
monitor.
Monitor Info: Indicates the model and serial numbers of your monitor.
Refresh Notifier: A message will advise you if the refresh rate of the
signal being applied to the monitor by the computer is too low. For further
information, please refer to your display card or system manual.