Connecting devices to the switch, Connecting devices to the switch -5, Figure 3-1 – Nortel Networks 70 Series User Manual
Page 41: Installing the switch in a rack -5
Installation
206375-A
3-5
3.
Using a #1 Phillips screwdriver, tighten the screws to secure each bracket.
4.
Hold the switch with the mounting holes in the brackets aligned with the
holes in the rack.
5.
Insert two screws, appropriate for your 19-inch rack, into each of the
mounting brackets and tighten the screws.
Figure 3-1.
Installing the Switch in a Rack
Connecting Devices to the Switch
You can connect the BayStack 70 Series 10/100 Ethernet Switch to any device
that conforms to the IEEE 802.3 Ethernet standard, such as the following devices:
•
Ethernet networking devices
•
Individual workstations or servers
•
Other switches, bridges, or hubs
The HDX/FDX LED on all BayStack 70 Series 10/100 Ethernet Switch front
panels indicates whether the switch is operating in half- or full-duplex mode.
When the HDX/FDX LED is on, the port is operating in full-duplex mode
(meaning the port is operating at either 20 Mb/s or 200 Mb/s, depending on the
connecting device). When the HDX/FDX LED is off, the port is operating in
half-duplex mode, which is 10 Mb/s or 100 Mb/s.
9350FA
70-24T Switch