Nortel Networks 70 Series - Manual (Page 24)

Installation and Reference for the BayStack 70 Series 10/100 Ethernet Switches
1-8 206375-A
DC Power Adapter
The BayStack 70-8T 10/100 Ethernet Switch and BayStack 70-16T 10/100
Ethernet Switch are shipped with a power adapter and cord, as shown in
Figure 1-7 .
Figure 1-7. DC Power Adapter
The BayStack 70-8T 10/100 Ethernet Switch is shipped with a 5 V DC/3 Amp
power adapter. Be sure to use this 3 Amp adapter only with the 8-port switch.
The BayStack 70-16T 10/100 Ethernet Switch is shipped with a 5 V DC/4 Amp
power adapter. Be sure to use this 4 Amp adapter only with the 16-port switch.
Cable Holder
A small plastic clip, or holder, can be screwed into the base of the switch to hold
the power adapter cable in place. The hole for the cable holder is located on the
bottom of the switch, near the DC power receptacle.
Warning: Use only the power adapter that was shipped with your switch to
supply power to that switch. Read the amperage label on the power adapter to
be sure it is the correct adapter for your switch.
Do not use the 8-port adapter (5 V DC/3 Amp) with a 16-port switch.
Do not use the 16-port adapter (5 V DC/4 Amp) with an 8-port switch.
Power cord
adapter
9331FA