Installation and connections, E-12, Setting up the screen and the projector – NEC MT1065 User Manual
Page 16
E-12
3
1
2
INSTALLATION AND CONNECTIONS
This section describes how to set up your projector and how to connect video and audio sources.
To the wall outlet.
Setting Up the Screen and the Projector
Selecting a Location
The further your projector is from the screen or wall, the larger the image. The minimum size the image can be is approximately 25" (0.64 m)
measured diagonally when the projector is roughly 39.4 inches (1.0 m) from the wall or screen. The largest the image can be is 500" (12.7 m) when
the projector is about 614.2 inches (15.6 m) from the wall or screen. Use the drawing below as a guide.
Your projector is simple to set up and use.
But before you get started, you must first:
z
Set up a screen and the projector.
x
Connect your computer or video equip-
ment to the projector. See page
E-14 – 17.
c
Connect the supplied power cable. See
page E-17.
NOTE: Ensure that the power cable and any
other cables are disconnected before moving
the projector. When moving the projector or
when it is not in use, cover the lens with the
lens cap.
300"
240"
406.4(W)X304.8(H)/160(W)X120(H)
365.8(W)X274.3(H)/144(W)X108(H)
304.8(W)X228.6(H)/120(W)X90(H)
243.8(W)X182.9(H)/96(W)X72(H)
203.2(W)X152.4(H)/80(W)X60(H)
162.6(W)X121.9(H)/64(W)X48(H)
121.9(W)X91.4(H)/48(W)X36(H)
81.3(W)X61.0(H)/32(W)X24(H)
61.0(W)X45.7(H)/24(W)X18(H)
TELE: 50.8(W)X38.1(H)/20(W)X15(H)
Lens center
Screen Size
1.4
2.1
2.8
3.5
4.3
5.3
6.4
8.5
1.1
1.0
200"
180"
150"
120"
100"
80"
60"
40"
30"
25"
609.6(W)X457.2(H)/240(W)X180(H)
Screen size (Unit: cm/inch)
487.7(W)X365.8(H)/192(W)X144(H)
7.1
Distance (Unit: m)
10.6
WARNING: To avoid premature lamp failure, do not tilt the front of the
projector up or down by more than 15
° from level.