Navigon 7110 - Manual (Page 32)

User's manual NAVIGON 7100 | 7110
- 32 - Routes with stages
7.2 Managing routes
You can save each planned route under a particular name.
Note: Only the start point and route points will be saved, not, however,
the calculated route. If you load a route that has been saved, it must be
recalculated before navigation can begin.
You can load, rename or delete stored routes.
7.2.1 Saving routes
The R OUTE P LANNING window is open. You have entered the starting
point and at least one route point.
1. Tap
on Options > Save Route.
2. Enter a name for the route.
3. Tap the Save button.
The destination is now saved to the S AVED R OUTES list. The dialog
window closes.
7.2.2 Loading routes
1. Tap on Options > Saved Routes.
2. Tap the route that you want to load.
3. Tap the Load Route button.
The R
OUTE
P
LANNING
window opens. The starting point and the
route points of the loaded route have been entered.
7.3 Navigation
The route must be calculated first. You may then begin navigation or
just simulate it.
7.3.1 Calculating and displaying routes
It is possible to calculate and display a planned route on the map even
without GPS reception in order to get an impression of the journey.
The R
OUTE P LANNING window is open. The starting point and at least
one route point have been entered.
1. Tap the Show Route button.
The map window opens in Preview mode.
The starting point and the route points are marked by flags. For
each stage, the distance and the estimated trip time is given. This
data is also displayed for the entire route.