Navigon 7110 - Manual (Page 10)

User's manual NAVIGON 7100 | 7110
- 10 - Before you begin
2.3.3 Preparing the navigation system for use
Caution! Please be sure to refer to the safety information in chapter
"Important safety information" on page 11.
Securing the cradle
1. Clean that part of the windscreen to which you would like to secure
the cradle. The windscreen must be dry and free of dirt and grease.
2. Using the suction cup, fix the cradle provided to the windscreen.
The cradle should be as level as possible.
3. Press the lever on the suction cup down.
Securing the navigation device to the cradle
The navigation device is secured to the cradle by means of a bayonet
fitting. This connection functions in a similar way to attaching a lens to a
camera or putting the lid on a pressure cooker.
1. Place the navigation device on the bayonet in such a way that the
lugs on the bayonet ring correspond exactly with the recesses on
the cradle. This is achieved by rotating it approx. 45° to the left.
2. Turn the navigation device clockwise until the bayonet fitting locks
into place.
3. Adjust the navigation device so that it can be seen easily.
Supplying power to the navigation device
Included in delivery of the NAVIGON 7100 | 7110 is a car charger cable
with which power can be supplied to the navigation device via the
vehicle's cigarette lighter.
The car charger cable is connected to the NAVIGON 7100 | 7110 via
the mini-USB-socket on the bottom of the device.