NetComm NP5410 - Manual (Page 5)

Rev. 1 - YML675 www.netcomm.com.au
NP5410 Wireless Ethernet Bridge User Guide Page 5
Physical Details
Rear Panel
INIT Button “INIT” means “Initiation”. Press and hold this button
to reboot and reset the current configuration to factory
default settings. The left indicator “DIAG” on NP5410
will be off and then begin blinking. This initiation action
will be completed when the indicator “DIAG” light is
always green instead of blinking.
LAN Cable Selection Switch
X Crossover: The RJ-45 port Tx and Rx lines will be reversed. Use
this setting when you are connecting the supplied
straight through ethernet cable directly to a PC.
II Straight: The RJ-45 port Tx and Rx lines are normal. Use this
setting when you are connecting the supplied straight
through ethernet cable directly to a Hub or Switch.
Power Input Use the power adapter supplied with the NP5410
LAN Use standard Ethernet cable (RJ-45 connector) to
connect your PC, hub/switch or broadband router/
modem to this LAN port.
Antenna Connection
INIT Button
Selection Switch
LAN Cable
Power Input