NetComm NP5410 - Manual (Page 19)

Rev. 1 - YML675 www.netcomm.com.au
NP5410 Wireless Ethernet Bridge User Guide Page 19
WEP key 1 ~ 4: Enables you to create an encryption scheme for Wireless
LAN transmissions. You can manually enter a set of
values or use pass phrase to generate WEP keys.
For 64-bit WEP encryption, a key of 10 hexadecimal
characters in length must be filled in.
For 128-bit WEP encryption, a key of 26 hexadecimal
characters in length must be filled in.. Be sure that the
key in the AP shall be the same as in NP5410, otherwise
the communication will not work.
Enter pass phrase: Enter a pass phrase and click “generate” to generate
WEP keys from pass phrase.
Note: Some APs do not support 128-bit encryption
Note: 128-bit encryption requires more system resources than 64-bit encryption. Use 64-
bit encryption for better performance.
WEP key to use: Sets which WEP key (1 ~ 4) to use when sending data.
To connect to a Wi-Fi compliant wireless device, key #1
must be selected.
Note: You may need to reboot the NP5410, and then re-load the page to see any new
settings.