Nortel Networks BCM 4.0 - Manual (Page 10)

10 About the Key Expansion Module (KEM)
N0089554 N0089554
Make sure that features are programmed on your T7316E telephone or KIM by following the steps
below for programming memory buttons.
Moving line buttons
If you have an enhanced CAP, you can move external lines, target lines and hunt group
appearances from the buttons on the T7316E telephone
to buttons on your KIM.
Monitoring telephones in your system
It is important that you pay attention to the different types of indicators beside the internal autodial
buttons on your KIM. These indicators tell you the status of a telephone extension.
Internal autodial
1. Press ≤•¤.
2. Press a memory button.
3. Dial the extension number.
4. Press OK to store the number.
Or
Press Quit to exit the programming
sequence.
External autodial
1. Press ≤•⁄.
2. Press a memory button.
3. Dial the external number.
4. Press OK to store the number.
Or
Press Quit to exit the program-
ming sequence.
Features
1. Press ≤• ‹.
2. Press a memory button.
3. Press ≤ and enter the feature
code.
4. Press OK to store the feature code.
Or
Press Quit to exit the programming
sequence.
How to erase memory buttons
1. Press ≤•⁄.
2. Press a memory button.
3. Press OK to erase the button.
Or
Press Quit to exit the program-
ming sequence.
1. Press ≤•°⁄.
2. On your T7316E telephone, press the line button for the line you want to
move.
3. On your KIM, press the memory button where you want the line to go.
4. Press ®. The line button now appears on your KIM.