Napco Security Technologies GEM-X255 - Manual (Page 33)

33
S Y S T E M T R O U B L E E R R O R C O D E S
Trouble
Indication
System Trouble
Condition
Action
E04-NNN Wireless Transmitter
Supervisory Failure A problem has been detected with a wireless transmitter. Call installing company for service
E05-NNN Wireless Transmitter
Low Battery The battery in a wireless transmitter is low and should be replaced. This transmitter is on the
zone corresponding to the number NNN. The replacement battery for the GEM-TRANS2
door/window transmitter, GEM-PIR motion detector and GEM-GB glass break detector is the
Duracell DL123A 3 volt lithium. (2 required for the GEM-PIR and GEM-GB.) The replacement
battery for the GEM-SMK is the Duracell MN1604 9 Volt Alkaline (2 required). The GEM-DT Dual
Technology Sensor requires 4 C cell alkaline batteries.
Warning: Replace batteries only with the same type as specified above. Use of another battery
may present a risk of fire or explosion. Do not recharge or disassemble battery, or dispose of in
fire.
E06-NN Receiver Response
Failure Call installing company for service.
E07-00 Download Failure Call installing company for service.
E08-00 Telephone Line Cut The telephone line has failed. If telephone service has been temporarily interrupted, the trouble
will clear automatically when it is restored. Otherwise, call installing company for service.
E09-00 System Cold Start
GEM-X255_OI273_USER.pub
page 33 Tuesday, September 10, 2002 13:14