Napco Security Technologies GEM-X255 User Manual
Page 19
19
K E Y P A D F U N C T I O N S
Activate Program? Activates the Program Mode from Keypad No. 1. Note: This
feature is disabled while armed . (See PROGRAMMING USER CODES)
Activate Download? For installer's use only. If accidentally enabled, press
C
to exit. Note: This feature is disabled while armed.
Relay Control?
(Relay Control programmed?
!
YES
!
NO
).
Turns ON or OFF one or more programmed Relay Groups. Press
J
to turn the
displayed group on or off; press NEXT(
E
) to proceed to the next group, or
PRIOR (
F
) to scroll back to the previous group. Press
C
when done.
•
Relay Group 01: [ ____________________________________ ]
•
Relay Group 02: [ ____________________________________ ]
•
Relay Group 03: [ ____________________________________ ]
•
Relay Group 04: [ ____________________________________ ]
•
Relay Group 05: [ ____________________________________ ]
•
Relay Group 06: [ ____________________________________ ]
•
Relay Group 07: [ ____________________________________ ]
•
Relay Group 08: [ ____________________________________ ]
A C T I V A T E
P R O G R A M Y / N
A C T I V A T E
D O W N L O A D Y / N
R E L A Y
C O N T R O L Y / N
GEM-X255_OI273_USER.pub
page 19
Tuesday, September 10, 2002 13:14