beautypg.com

Napco Security Technologies GEM-X255 User Manual

Page 30

background image

30

G L O S S A R Y

INTERIOR Button - Bypasses

Interior Zones on arming (see Zones -
Interior Zones).

Instant Protection - Arming without

entry delay using the

F

button

while remaining on the premises.

Keypad - Puts control-panel

functions at your fingertips. It can be
mounted anywhere in your premises.

Manager's Mode - In a partitioned

system, a low-security operating
mode that allows arming by area.

Panic Buttons - Blue buttons on the

keypad (

G

and

7

,

8

or

9

). If enabled, pressing

G

together with

7

,

8

or

9

will alert the central station of

a fire, auxiliary, or police emergency.

Partitioned System - A system that

has been subdivided into two or more
(up to eight) independent subsystems
(areas).

Pre-Alarm Warning. - A keypad

sounder alert of an impending
alarm. This option is programmable
by zone for the same duration as
that programmed for Abort Delay
(see Abort Delay).

Report - A transmission to a

central station notifying of a change
in the status of the system (alarm,
trouble, low battery, etc.).

RF Low Battery - (Wireless sys-

tems only) Weak transmitter
battery.

RF Check In - (Wireless systems

only) Periodic test report from
transmitter (if a report is not
received on time, a supervisory-
failure system trouble will result).

Ringback - A beep after arming

verifying the central-station's receipt
of a closing report.

Service Code - A code intended

for temporary use.

Sounder - A local warning device

at each keypad to alert that (a) entry
delay has started; (b) an attempt was
made to arm with a zone in trouble;
(c) a Day-Zone condition exists (see
Zones: Day Zone); (d) 10 seconds
exit time remaining; (e) invalid code
entered; or (f) central station
acknowledged arming (see
Ringback).

System Trouble - A problem (low

battery, power failure, etc.) detected
in the system.

Trouble - A zone fault; an open

door, window, or other problem that
may prevent arming.

User Code - Your personalized

code for arming and disarming the
system. It may contain up to six digits.

GEM-X255_OI273_USER.pub
page 30

Tuesday, September 10, 2002 13:14