Nortel Networks 1100 - Manual (Page 9)

Regulatory and safety information 9
IP Phone 1110 User Guide
The user should not make changes or modifications not expressly approved by Nortel Networks.
Any such changes could void the user’s authority to operate the equipment
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la
classe A est conforme à la norme NMB-003 du Canada
Warnings:
• This is a Class A product. In a domestic environment this product can cause radio
interference in which case the user must take adequate measures.
European
Community EN 55022 Class A Emissions: Information technology
equipment - Radio disturbance
EN 55024 Information technology equipment -
Immunity characteristics
Limits and methods of measurement
EN 61000-3-2 Limits for harmonic current emissions
(equipment input current <= 16 A per
phase)
EN 61000-3-3 Limitation of voltage fluctuations and flicker
in low-voltage supply systems for
equipment with rated current <= 16 A
Note: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Note: The user should not make changes or modifications not expressly approved
by Nortel Networks. Any such changes could void the user’s authority to operate
the equipment.
Table 2 EMC compliance
Jurisdiction Standard Description