Nikon COOL PIX S1 - Manual (Page 19)

9
First Steps
4 Charge the battery
The indicator lamp next to the camera monitor
will blink green while the battery charges. During
charging, battery status is shown as follows:
Indicator lamp Description
Blinks Battery charging.
On Battery fully charged.
Flickers
Check that camera is correctly inserted in COOL-STATION. If cam-
era is correctly inserted, battery requires replacement.
About two hours are required to charge a fully depleted battery.
5 Remove the camera from the COOL-STATION
When charging is complete, remove the camera from the COOL-STATION
and unplug the AC adapter.
Removing the Battery from the Camera
Turn the camera off before removing or inserting batteries.
To eject the battery, slide the battery latch in the direction
shown. The battery can then be removed by hand. Note that
the battery may become hot during use; observe due caution
when removing the battery.
EN-EL8 Batteries
Before using the EN-EL8, read and follow the warnings and cautions on pages
ii–iii and 85 of this manual.
The EH-63 AC Adapter
The supplied EH-63 AC adapter can also be connected di-
rectly to the camera as shown at right. Whether connected
directly to the camera or to the MV-11 COOL-STATION, the
EH-63 can be used to power the camera or to charge the bat-
tery. Do not, under any circumstances, use another make
or model of AC adapter. Failure to observe this precaution
could result in overheating or in damage to the camera.
When connecting the adapter, be sure the DC plug is in the correct orientation.
Inserting the plug upside down could damage the camera or COOL-STATION.