Fcc warning, Installation precautions – PhatNoise Car Audio System User Manual

Page 51

Appendix C: Important Safety and Handling
Instructions

FCC WARNING

This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless the
modifications are expressly approved in the instruction manual. The user
could use the authority to operate this equipment if an unauthorized change
or modification is made.

NOTE

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a

residential installation. This equipment may cause harmful interference to
radio communications, if it is not installed and used in accordance with the
instructions. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and the receiver

•

Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected

•

Consult the dealer or an experienced radio/TV technician for help.

PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS

Installation Precautions

Mounting location precautions to ensure and observe:

1. The unit is not subject to direct sunlight.

2. The unit is not near heat sources (such as heaters).
3. The unit is not exposed to rain or moisture.
4. The unit is not exposed to excessive dust, sand or dirt.
5. The unit is not subject to excessive vibration.
6. The fuel tank should not be damaged during installation.

7. There should be no wire harnesses or pipes under the place where you
are going to install the unit.
8. The spare tire, tools or other equipment in or under the trunk should
not be interfered with or damaged.
9. Make holes only after making sure there is nothing on the other side of
the mounting surface.

Page 51