Patton electronic 4630 Series - Manual (Page 26)

Installing the gateway router 26
SmartNode 4630 Getting Started Guide 3 • SmartNode installation
Connecting the power supply
Do the following to connect the main power to the Model 4630:
Note Do not connect the power cord to the AC power outlet at this time.
1. Insert the female end of the AC power to the mains port (see figure 2 on page 15).
2. Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to “Contacting Patton for assistance” on page 33 to find out how to replace it with a compatible
power cord.
3. Connect the male end of the AC power cord to an appropriate AC power outlet.
Figure 6. Power LED (SmartNode 4638 shown)
4. Verify that the green Power LED is lit (see figure 6 ).
Internal S-Bus power supply
The Model 4630 supplies S-Bus line power on the BRI ports that can be activated individually for each port. If
a port is switched to TE mode, line power is switched off. A total of 4W are available.
Congratulations, you have finished installing the SmartNode Gateway Router! Now go to chapter 4, “Initial
configuration” on page 27.
The internal power supply automatically adjusts to accept an
input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
CAUTION
Power