Panasonic DMR-E55 - Manual (Page 42)

42
RQT7301
Re
fe
re
n
c
e
Error messages
On the television Page
On the unit’s display
Cannot finish recording
completely. pThe program was copy-protected.
pThe disc may be full. —
—
Cannot play. pYou inserted an incompatible disc (Discs recorded in PAL video etc.). —
Cannot record on the disc. pThe disc may be dirty or scratched. 15
Unable to format.
Please check the disc.
Cannot record. Disc is full. pCreate space by erasing any unnecessary titles. [RAM]
pUse a new disc. [RAM] [DVD-R] 24, 29, 33
—
Cannot record. Maximum
number of titles exceeded.
Error has occurred. Please
press ENTER. pPress [ENTER] to start recovery process. You cannot operate the unit while it is recovering
(“SELF CHECK” appears on the unit’s display).
—
No disc pThe disc may be upside down. —
Please change the disc. pThere may be a problem with the disc. Press [ OPEN/CLOSE] to remove it and check it
for scratches or dirt. (The unit turns off automatically after you open the tray.)
15
This is a non-recordable disc. pThe unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R.
pYou inserted an unformatted DVD-RAM. Format the disc with this unit. —
33
This disc is not formatted
properly.
pThe operation is prohibited by the unit or disc. —
CHK REMOTE
(“ t” stands for a number.)
pThe remote control and main unit are using different codes. Change the code on the
remote control.
Press and hold [ENTER] and the indicated number button at
the same time for more than 2 seconds.
14
HARD ERR pIf there is no change after turning the unit on and off, consult the dealer where the unit was
purchased.
—
NO READ pThe disc is dirty or badly scratched. The unit cannot record, play, or edit.
pYou have used a DVD-RAM/PD lens cleaner and it has finished. Press [ OPEN/CLOSE]
to eject the disc.
15
—
PROG FULL pThere are already 16 timer programs. Delete unnecessary timer programs. 21
SELF CHECK pThere was a power failure or the AC plug was disconnected while the unit was on. The unit
is carrying out its recovery process. Wait until the message disappears.
—
UNSUPPORT pYou have inserted a disc the unit cannot play or record on. 15
U14 pThe unit is hot.
The unit switches to standby for safety reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when installing the unit. Do not block the cooling fan
on the rear of the unit.
—
U99 pThe unit fails to operate properly. Press [POWER ¦/I] on the main unit to switch the unit to
standby. Now press [POWER ¦/I] on the main unit again to turn the unit on.
—