Polaris Sportsmabn X2 500 EFI - Manual (Page 58)

55
OPERATION
Starting the Engine
WARNING
Engine exhaust contains poisonous carbon monoxide and can
cause loss of consciousness resulting in severe injury or death.
Never run an engine in an enclosed area.
1. Position the vehicle on a level surface.
2. Place the transmission in PARK.
3. Lock the parking brake.
4. Sit on the vehicle and turn the engine stop switch to RUN.
NOTE: Do not press the throttle while starting the engine.
5. Turn the ignition key past the ON position to engage the starter.
Activate the starter for a maximum of five seconds, releasing the
key when the vehicle starts. If the engine does not start, return the
key to the OFF position and wait five seconds before attempting to
start again. Activate the starter for another five seconds if
necessary. Repeat this procedure until the engine starts.
CAUTION
Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several minutes
before operating the vehicle.
Cold Weather Operation
If the ATV is used year-round, check the oil level frequently. A rising
oil level could indicate the accumulation of contaminants such as water
or excess fuel in the bottom of the oil tank. Water in the bottom of the
tank can lead to engine damage and must be drained. Water
accumulation increases as outside temperature decreases.
See your Polaris dealer for engine heater kits, which provide quicker
warm-ups and easier starting in colder weather.