Electrical requirements – Port-A-Cool SERIES 2000 User Manual
Page 8
PORT-A-COOL® Hazardous Location Units
*
Water supply inlet pressure should be limited to 50 psi maximum.
The cooling pads may now be replaced by reversing the removal operation above in Section I. Paragraph B.
Electrical Connection
PORT-A-COOL® unit must be upright and sitting on caddy with cooling pads installed!
These models utilize a single power cord and control switches. The power cord on this unit is 50’ of 14-gauge
3-wire grounded cord with out plug, so the unit can be wired to meet local code requirements. Check the chart below
to determine what the electrical requirements for your specific model may be. The use of separate multiple outlet
devices is not recommended.
When making electrical connections, insure that local and national codes are adhered to.
ELECTRICAL REQUIREMENTS
PORT-A-COOL®
VOLTS
MAX
MAX
MODEL
+- 10
FREQUENCY
AMPS
WATTS
PAC2K36EP
115
60
13.6
1200
PAC2K48EP
115
60
18.1
1750